MODULAR COVERINGS FOR AGRICULTURE AND INDUSTRY
TECHNICAL FEATURES
| Base (B) |
8,00 |
9,50 |
10,50 |
12,50 |
| Height (H) |
5,00 |
6,00 |
6,20 |
7,00 |
Minimum width of the module mt. 9.00 and then multiples of mt. 4.50
Structures with particular measurements can be realised on request.
ANCHORAGE BASE
The COPRIMAT structure anchorage bases is made up of a series of “L”- shaped pre-fabricated sections, placed at the sides of the covering and deposits, one following the other with a length measuring mt. 4.50 each and weighing 1450 Kg each in a way to statically balance the resulting pre-fabricated construction.
METAL STRUCTURE AND SUPPORT
The modular metal structure is made up of a series of “ribbed trusses” realised in electro-welded steel tubular with diameter and thickness that are appropriately dimensioned. These trusses are protected by a hot galvanising treatment and are connected to each other with cross-member tubes. These are also galvanised.
The junction between the support pipes and the connection pipes is realised by means of clamps with four holes that are internally galvanised.
The “ribbed trusses” are fixed to the base of the pre-fabricated “L”-shaped elements with SLM 16 - Fb16/25 type Fischers, which are adjusted with screw fasteners that have high mechanical hold.
The metal structure can be easily disassembled as it is made up of bolted elements. This allows a reduction of costs in the transport phases and new assembly.
COVERING SHEET
The covering is realised in Trevira bi-moulded PVC (polyvinyl chloride), 1100 Dtex yarn, warp and woof, 11 thread mesh on cm², weight 650 gr/m² breakage load 250 Kg on cm². Tearing strength 35 Kg, This material has high abrasion, tearing resistance qualities and good anti-aging qualities.
Available colours: White - Grey - Yellow - Orange - Red - Green - Blue.
The system used for anchorage of the sheet to the metal structure is realised using slotted and thermowelded reinforcements on the sides of the covering, while for fixing to the heads, an elastic rope is used that gives the sheet a constant tension.
Small attachment belts are thermowelded to the internal part of the sheet for good hold against the wind. These allow the perfect blocking of the covering onto the metal structure.
Any closing heads (front/rear) are also realised in bi-moulded PVC and are equipped with a relevant tubular attachment structure, which varies according to the closing system used (with sliding sheet doors or with sheet fixed up to ground).
On request we can also supply class II° fire-resistant PVC sheets
RESISTANCE TO STATIC AND AERODYNAMIC LOADS:
RESISTANCE TO THE SNOW LOAD
The “COPRIMAT” structure does not have particular structural risks regarding the snow load; due to its geometrical shape the upper part of the covering tends to unload the weight to the ground (structural calculations can be requested for each type of covering)..
RESISTANCE TO THE AERODYNAMIC LOAD OF THE WIND
Also in this case, requests are available for specific structural calculations for each type of covering.
The structures can be fixed onto:
- pre-fabricated bases in reinforced concrete for anchorage
- overlapping rails
- existing reinforced concrete trenches
- existing support bases
|
